Filter
Top Products
44008-01 • 02/10/10 • Hunter Fan Company
5
5
* The program time can be set in 10 minute increments, and remains the same for both Heat and Cool programs.
* The program temperature can be set in increments of 1°F (1°C).
* The Heat setpoint can not be set higher than the Cool setpoint, and the Cool set point can not be set lower than the Heat set
point except when the thermostat has been manually overriden.
* If the system selector is in AUTO mode, the current operating mode will be used for programming.
* After 15 seconds without a key press, the thermostat will return to normal display mode.
* When setting the program time, note the AM / PM indicator.
* With the Auto Recovery feature enabled, you do not need to set your comfort program times early. Auto Recovery will
determine how early to turn your system on, so that the room is comfortable at the program time.
* To check your set temperature press the
or once from the main screen and the current set temperature will be
displayed for 1 second then revert back to the main display.
2
.
Programming (Cont.)
Read the programming section thoroughly to ensure you understand your programming options and which will best t with
your lifestyle. e following notes should help you with programming:
e rst step in programming your thermostat is to set the current time and day.
To set the current time and day:
Press the
day/time
button once to activate day/time programming mode. e hour will be ashing. Use your and
buttons to change the hour.
NOTE: Remember, you must pass the 12th hour when setting your time to move between AM and PM modes unless in 24
hour time.
Press the
day/time
button again to move to minutes. Use the and buttons to adjust your minutes. Press the
day/time
button
once more to see the current day ashing. e and buttons will also change between the days of the week. Once set,
press
ret/clear
to return to the main screen.
Day / Time
ere is no need to stand at the wall where the thermostat is mounted while programming or changing features. Simply remove
the thermostat from the wall and make the necessary changes in the comfort of a chair. You can also set your programming
and features before you even install the thermostat.
Armchair Programming
Your thermostat can support 3 remote sensors that will measure the temperature from three dierent locations, two indoor
and one outdoor. It is recommended you follow the instructions for setting up the remote sensor in the Remote Sensor
Instruction Pamphlet before proceeding.
To configure your thermostat to work with the remote sensors:
is thermostat comes with one sensor that allows for temperature reading or control in an alternate location, away from the
thermostat. Up to 2 other sensors can be used in conjunction with the thermostat. is for sensor 1, for sensor 2, and is for
the outdoor sensor.
Press the
option
button 8 times to reach “channel”. Press the “ sensor” button to select which sensor to setup. You may select
for sensor 1, for sensor 2, or for the outdoor sensor.
Once this has been chosen, use the or buttons to change the channel on the thermostat to the communication
channel set on the sensor.
Note: e channel number has to match the channel number displayed in the bottom right corner of the sensor display after
it has been set.
At this time you can press the “ sensor” button again and setup another sensor, or press
ret/clear
to return to the main screen.
Note: Only 3 sensors can be setup at a time. e outdoor sensor nor sensor 2 can be used to control the temperature inside
the home. ey will only report temperature to the thermostat.
Remote Sensor Programming (Model 44668 only)