Filter
Top Products
Reinsert bolt through small holes
of handle and secure with nut.
Tighten nut with screwdriver.
Proceed to Section C.
2) Round handle
A. Put handle together
Remove cardboard from the end
of handle sections. Remove bolt
and nut from upper handle sec-
tion.
Slide the two handle sections to-
gether, making sure that both
cord storage hooks are on the
same side of handle. Insert bolt
through small holes and secure
with nut. Tighten nut with screw-
driver.
If the nut and bolt will not assem-
ble as shown in the illustration,
the holes in the handle are not
lined up correctly.
B. Attach handle to
the cleaner
Unscrew nut and remove bolt
and plate from handle bail.
Take assembled handle and place
so that the socket holes in the
bottom of the handle are directly
in line with the electrical prongs.
Position the handle so that the
ON-OFF switch is to the rear of
the cleaner.
Push down until handle is secure-
ly in place. Insert bolt into small
hole in front of handle.
6