Filter
Top Products
Adjustment for carpet
pile height
The cleaning of carpet and rugs
takes place at the nozzle. This is
the opening at the bottom of the
cleaner where the agitator is lo-
cated.
It is necessary to raise and lower
the nozzle for various carpet pile
heights. The adjustment lever
raises and lowers the nozzle for
various carpet pile and is located
to the right of the bag near the
bottom of the cleaner.
You can most easily make nozzle
adjustments if you move the lever
UPWARDS with your toe until
the lever “clicks” into the desired
position. Therefore, when a
downward adjustment is requir-
ed, first press the lever all the
way down into the SHAG posi-
tion and then move upward one
position at a time.
Pile height adjustment
indicator
The indicator for the selected
carpet pile height is at location of
the adjustment lever, Fig. 1, or
shown in the window on top of
the cleaner hood, Fig. 2.
Select the adjustment for the carpet pile height according to the chart below.
Low
for low pile and kitchen carpet
Normal for carpet with normal pile height and for removing loose dirt
from hard surface floors
i
High
for carpet with normal pile height but thicker density; if the
cleaner is difficult to push at “Normal”, move the lever to the
“High” position.
Shag
for very long or shag pile carpet
Note: If the “Low” setting is used on a higher pile carpet, there is an in-
crease in the belt load and pushing effort is greatly increased.
10