Filter
Top Products
How to replace the brushes
(Brushes
-
HOOVER part No. 48445001)
Disconnect cleaner from electrical outlet.
1.
To replace worn brushes, remove bottom plate, belt and agitator, fol-
lowing directions given on preceding pages.
2. Turn end plates of agitator in
opposite directions until one end
plate comes off.
3. Then pry out end section as
shown.
4. Remove opposite end plate
and shaft by pulling straight out.
Pry out remaining end section.
5. Remove brushes by pulling them
from agitator. Use pliers if neces-
sary. Slide new brushes into chan-
nels. Push them in as far as possi-
ble.
I
END SECTION
6. To reassemble, reverse proce-
dure. Replace the last end sec-
tion removed, then end plate and
shaft. Replace remaining end sec-
tion and end plate. Be sure end
sections are assembled with loca-
tor lined up with slot in agitator.
7. Should you accidentally dis-
place the bearing during disas-
sembly, reassemble as shown.