Filter
Top Products
The headlight
How to replace the headlight
Disconnect cleaner from electri-
cal outlet.
This cleaner uses 12 volt, wedge
base type 912 bulbs.
1.
Set adjustment lever for pile
height to the “NORMAL” or
“HIGH” position.
2. Turn cleaner over and remove
the two screws indicated in the il-
lustration. Place cleaner in the
upright position and remove
hood.
3. Remove bulb by pulling
straight out of socket. Replace by
pushing bulb straight into socket
until it locks in place.
4. Replace hood and screws.
Tighten screws securely.
The belt
The belt of your cleaner causes the agitator to rotate and is important for
the effective operation of the cleaner. The belt is located under the bot-
tom plate of the cleaner and should be checked from time to time to be
sure it is in good condition.
When to replace the belt
To check the belt, remove the bottom plate (see following section). If the
belt is stretched, cut or broken, replace the belt.
What belt to buy
To assure effective operation, use only genuine HOOVER belts with your
cleaner. When purchasing a new belt ask for HOOVER part No. 49258.
17