Honeywell LYNXR Series Home Security System User Manual


 
–49–
System Operation
Speaker Phone Operation (LYNXR-EN Only)
To place a call or answer a call using the speaker phone:
[#] + AUX
To flash (switch between two calls using call waiting): AUX
To hang up and exit speaker phone mode: OFF
To enable/disable (toggle) ringer: [#] + VOLUME + AUX
To return the keypad to telephone mode after disarming the system: [#] + AUX
Remote Phone Control Feature
The remote phone control feature, which must be enabled in field
91, allows the user to access the security
system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring
count specified in field
95, and will announce “SYTEM” every three (3) seconds for the next eight (8)
seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is
not entered or the eight (8) second period expires a modem tone will be generated for remote programming
(Compass Downloading). If a valid User Code has been entered, the control will announce the current system
status and/or beeping sounds.
Keypad Functions
Remote Phone Control Feature
To remotely disarm system:
+ [1]
To remotely arm in AWAY mode:
+ [2]
To remotely arm in STAY mode:
+ [3]
To remotely arm in AWAY or STAY with no delay:
+ [2] or [3] + [0]
To remotely activate X-10 devices 1-6: [#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:
+ [#] + [4] + device no.
To remotely deactivate X-10 devices 1-6: [#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:
+ [#] + [7] + device no.
To remotely Bypass zones:
+ [6] + zone no.
To remotely activate Forced Bypass:
+ [6] + [#]
To remotely check system status: [
]
To end remote phone control session: Hang Up or
+ [9]
Quick Arm Note
The installer code and
babysitter code cannot
disarm the system i
f
armed by Quick Arm
method.
NOTE
The ARMED and READY LEDs blink alternately
when the Speaker Phone is active.