Filter
Top Products
IPGSM-DPC Commercial Fire Communicator – Installation and Setup Guide
– 5 –
4. Connect the LED Display board to its connector, then slide the board into the mounting rails. (Refer
to the “LED Display Information” topic if a wire is detached from its connector.)
5. Carefully remove the packaging material that surrounds the PowerBoost1.
6. Mount the PowerBoost1 on the three unused standoffs. Use the plastic screw
(prevents shorting)
to secure the upper right corner of the PowerBoost1 and the two metal screws and lock washers to
fasten the left side of the circuit board. Ensure the lock washers are located between the circuit
board and the head of the two metal screws.
7. Use the 1451-UL9 Wired Transformer directly connected to un-switched facility power. Connect and
route 14AWG (minimum) insulated wire from facility ground to the 1451-UL9 enclosure ground post
and through the conduit to the IPGSM-DPC cabinet ground post.
8. Route 16AWG wire from the transformer secondary, through the conduit. Pass the wires through
the Ferrite Filter, then loop the wires back through again making a loop. (Ensure the wire ends that
connect to the PowerBoost1 Module are tinned.) Connect the wires to the PowerBoost1 AC
terminals. At this time DO NOT apply power.
9. Ensure all ground connections are tight.
10. Connect the Ethernet cable and the Telco 1 and Telco 2 lines. If you choose to use an optional
Cabinet Tamper Switch (if the control panel supports it) mount and wire it.
Note: The Ethernet cable, Telco 1, Telco 2 lines, and the optional cabinet Tamper Switch (if used)
must be run through conduit.
11. Verify the PowerBoost1 module DIP switches are configured as shown below.
iPGSM-COM-008-V0
PowerBoost1
15
ON
2
3
4
15
ON
2
3
4
(Switch handle = white)
12. Ensure the following:
LED Display board is fully seated.
All wiring terminals and connectors are tight.
All wiring has been completed and secured with cable ties.
13. Install the battery (not supplied). Apply power to the 1451-UL9 Wired Transformer, and attach the
battery cable.