Filter
Top Products
19
• Quick Menu
All user codes default to the quick menu. This menu is made up of
a selection of ten options (0 – 9) from the menu options 11 – 68.
The user code level controls access to the quick menu. Any user
can be upgraded from the quick menu to the full menu by assigning
a * to the user while the Modify Level option is accessed. Therefore
a user with a level *5 would have access to the full menu from
options 11 – 39. No code can access both menus.
Note: The manager code defaults to the quick menu on the
Galaxy 8 and 18, but defaults to the full menu on the Galaxy
60, 128, 500, 504 and 512.
Modify Name
This allows a name to be assigned to the user (maximum 8 characters).
Each of the user codes default to the name USER and the manager
defaults to MGR. The manager name cannot be changed. On selecting
the Modify Name option, a section of the alpha-numeric that can be
assigned to the user name is displayed on the bottom line of the keypad;
the cursor flashes on the letter L. Press * to erase the letters of the
default or previous name. When the previous name has been erased,
use the A> or <B keys to move the cursor to the first letter of the name
and press the ent key. The selected character appears on the top line,
continue this process until the name is completed. The # key toggles
between upper and lower case characters and the system library. Press
esc to save the name and exit.
Time Zone (Galaxy 60, 128, 500, 504 and 512)
Managers can allocate time zones to user PINs when TIMERS have
been programmed by the engineer. Time zones are used to disable the
user PIN during the times (ON to OFF) programmed in TIMER A
and B.
When 4 = TIME ZONE displays, press the ent key . Using the A> key
select the time zones option to be allocated to the PIN. The following
time zones options are available:
0=OFF
1=TIMER A
2=TIMER B
3=TIMER A+B
The times assigned to Timer A and Timer B can be viewed using
option 45 Timer Control. No access will be granted if a code, assigned
to 1=Timer A, 2=Timer B or 3= Timer A+B is entered out with the
assigned times, an Illegal Code event is recorded in the log and any
outputs programmed as Illegal Code are activated.