Filter
Top Products
User Code Setup (Cont'd)
37
SCREEN ACTION
7. Select the partitions and access level
for this user. After the access level is
selected, the Allow Arm/Disarm from
other partitions box becomes available
when interfacing with commercial panels.
(On residential panels, this box is
automatically selected and cannot be
deselected.)
If this user is to be able to Arm and
Disarm from other partitions in commercial
panels, touch this box.
8. Touch the box below the User
Number. The "User Number" screen is
displayed with the instructions to Enter 3
Digits.
Note: When assigning User Numbers for
residential panels, enter 0 as the first of
the three digits.
9. Enter the 3-digit user number for this
user. The “User Options” screen is
displayed with the user’s name, number,
and code displayed.
10. If this user is assigned an RF button
zone, touch the box below the RF Button
Zone. The "RF Button Zone " screen is
displayed with the instructions to enter 3
digits. If interfacing to a residential panel,
enter 0 as the first digit. Enter the RF
Button Zone number that was previously
programmed in the control panel. Note
that the RF Button Zone does not appear
for every user. The User Options screen
will be redisplayed.
11. Press the SAVE button. The system
will save the configuration. When the
save is complete, the User Setup screen
is displayed with the new user’s name
shown.