Filter
Top Products
Troubleshooting
26
4
When using wireless LAN,
is the access point correctly
set?
Confirm access point settings when in Infrastructure mode. De-
pending on the access point, client access may be limited by the
MAC address.
Also, confirm there are no problems in transmission between ac-
cess point and wired clients, and between access point and wire-
less clients.
When using wireless LAN,
is the LED on the wireless
LAN card lit or blinking?
Confirm the orange LED is lit, and the green LED is lit or blinks
during transmission.
Is the wireless LAN being
used in Ad Hoc mode?
If so, turn the main power switch off and on. Also, changing some
of the settings in [Network] on the [Interface Settings] tab in [System
Settings] on the display panel may solve the problem.
Did you change the option
settings on the machine?
When using the RPCS™ printer driver on Windows 2000 and con-
necting with IEEE 1394, an error may occur if you change the op-
tion settings on the machine. In this case, follow the procedure
below:
A
Unplug the IEEE 1394 interface cables connected to the com-
puter.
B
Run the utility tool for the IEEE 1394 interface board, which is
stored in the following path on the CD-ROM labeled “Printer
Drivers and Utilities”.
\UTILITY\1394\
Reference
For more information about using the utility tool for IEEE
1394, see the README file in the same directory on the CD-
ROM.
C
Restart the computer.
D
Connect the computer to the machine using the IEEE 1394 in-
terface cables.
Possible Cause Solutions