Filter
Top Products
16
Combi HP thermostatic mixer shower
Fit the flush mount cover (fig.37). Locate the
lugs on the trim ring in the holes on the cover
(fig.38) and twist clockwise.
Complete the fitting of your shower accessories.
Hollow wall
The wall mounting bracket supplied with the
shower is suitable for use on a plasterboard wall
of 9.5 mm or 12.5 mm in thickness.
Decide on the shower position and whether
the hot and cold water supplies will enter the
shower from the top (falling), the bottom (ris-
ing) or the rear.
Mark an opening as shown plus the route of
inlet and outlet pipework (fig.39).
Note: The final separation between pipe
centres needs to be about 153 mm but absolute
accuracy is not essential as the inlet elbows are
adjustable between 146 mm and 160 mm.
Take out the plasterboard and offer the
mounting bracket up to the wall (fig.40). Mark
the outer fixing holes and drill. Insert the wall
bracket into wall cavity and secure using the
bolts and washers provided (fig.41).
If a fixed head is to be installed, the outlet
adaptor needs to be fitted into the top outlet
hole in the valve housing (fig.16). The adaptor
is sealed with an ‘O’ ring. Make sure the adaptor
is fitted with the hose end in the valve housing
(fig.17). Fit the blanking plug into the bottom
outlet hole using an ‘O’ ring to seal it.
If a bulkhead outlet is to be fitted, the outlet
adaptor needs to be fitted into the bottom
outlet hole in the valve housing. The adaptor is
sealed with an ‘O’ ring (fig.16). Make sure the
adaptor is fitted with the hose end in the valve
housing (fig.17). Fit the blanking plug into
the top outlet hole using an ‘O’ ring to seal it
(fig.18).
If installing a fixed head, make a hole in the wall
for the fixed head pipe.
Note: If fitting a fixed head, the hole in the wall
for the pipe must be close to 15 mm diameter as
possible. It must not exceed the diameter of the
special lock washer, otherwise a larger diameter
washer will have to be placed behind the lock
T00257
T00259
65 mm 77.5 mm
220 mm
115 mm
35 mm
Opening needs
to be at the bottom
if using a bulkhead
77.5 mm
T00258
Fig.37
Fig.38
Fig.39