Filter
Top Products
Heatilator • Evolution • 4065-114 Rev. o • 11/11 57
G. Place the Glass Media
WARNING! Risk of Explosion! Follow glass media
placement instructions.
• DO NOT place glass media in pilot opening.
• DO NOT place glass media where they might fall into
pilot opening.
• DO NOT use any media other than the glass media
supplied with this fi replace.
• DO NOT place more than one layer of glass media on
top of burner.
Improperly placed glass media interferes with proper burner
operation. Delayed ignition could occur.
Install the Glass Media
• Remove the screws holding the glass media placement
jig. Leave the jig in place until the glass media is
placed.
Figure 15.3 Remove Screws from Jig
• Open the bag of glass media and place on the burner/
hearth pan area.
• Spread the glass media over the entire area. Make sure
glass media is only one layer thick on top of the
burner.
Jig
Glass Media
Figure 15.4 Place & Spread Glass Media
• Remove the glass media placement jig.
• Make sure the area in front of the pilot remains free of
glass media.
Pilot opening must
be kept free of glass media!
Figure 15.6 Pilot Open & Glass-Media-Free
Figure 15.5 Remove Jig
Cleaning the Glass Media
During shipment of the glass media, dust and debris can
accumulate. We recommend the glass media be rinsed
thoroughly with water to remove dust and small glass
particles.
• Place the glass media into a bucket and rinse thoroughly
with water.
• Allow the glass media to dry before installing it into the
fi replace.
WARNING! Choking Hazard! Keep glass media out of
reach of children.