Filter
Top Products
Heatilator • Evolution • 4065-114 Rev. o • 11/11 3
Safety Alert Key:
• DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury.
• WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury.
• CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
• NOTICE: Used to address practices not related to personal injury.
Table of Contents
A. Congratulations 2
B. Limited Lifetime Warranty 5
1 Listing and Code Approvals
A. Appliance Certifi cation 7
B. Tempered Glass Specifi cations 7
C. BTU Specifi cations 7
D. High Altitude Installations 7
E. Non-Combustible Materials Specifi cation 7
F. Combustible Materials Specifi cation 7
G. Electrical Codes 7
H. Requirements for the Commonwealth of
Massachusetts 8
User Guide
2 Operating Instructions
A. Gas Fireplace Safety 9
B. Your Fireplace 9
C. Fan Kit (optional) 10
D. Clear Space 10
E. Decorative Doors and Fronts 10
F. Fixed Glass Assembly 10
G. Remote Controls, Wall Controls and Wall Switches 10
H. IPI Battery Tray/Battery Installation 11
I. Control Module Operation 11
J. Before Lighting Fireplace 11
K. Lighting Instructions (IPI) 12
L. After Fireplace is Lit 13
M. Frequently Asked Questions 13
3 Maintenance and Service
A. Maintenance Tasks-Homeowner 14
B. Maintenance Tasks-Qualifi ed Service Technician 15
Installer Guide
4 Getting Started
A. Typical Appliance System 16
B. Design and Installation Considerations 17
C. Tools and Supplies Needed 17
D. Inspect Appliance and Components 17
5 Framing and Clearances
A. Select Appliance Location 18
B. Construct the Appliance Chase 19
C. Clearances 20
D. Mantel and Wall Projections 21
6 Termination Locations
A. Vent Termination Minimum Clearances 22
7 Vent Information and Diagrams
A. Approved Pipe 24
B. Vent Table Key 24
C. Use of Elbows 24
D. Measuring Standards 24
E. Vent Diagrams 25
8 Vent Clearances and Framing
A. Pipe Clearances to Combustibles 35
B. Wall Penetration Framing 35
C. Install the Ceiling Firestop 36
D. Install Attic Insulation Shield 37
9 Appliance Preparation
A. Top Vent 38
B. Rear Vent 39
C. Secure and Level the Appliance 40
10 Install Vent Pipe
A. Assemble Vent Sections (DVP Only) 41
B. Assemble Vent Sections (SLP Only) 42
C. Assemble Slip Sections 42
D. Secure the Vent Sections 43
E. Disassemble Vent Sections 43
F. Install Decorative Ceiling Components
(SLP only) 44
G. Install Metal Roof Flashing 45
H. Assemble and Install Storm Collar 45
I. Install Vertical Termination Cap 46
J. Heat Shield Requirements for Horizontal
Termination 46
K. Install Horizontal Termination Cap 47
11 Shrouds
A. HHT Shrouds 48
B. Field Constructed Shrouds 48
12 Gas Information
A. Fuel Conversion 50
B. Gas Pressure 50
C. Gas Connection 50
D. High Altitude Installations 50
13 Electrical Information
A. Wiring Requirements 51
B. IntelliFire Plus™ Ignition System Wiring 51
C. Optional Accessories Requirements 51
D. Electrical Service and Repair 52
E. Junction Box Installation 53
F. Wall Switch Installation for Fan (Optional) 53