Filter
Top Products
Heatilator • Evolution • 4065-114 Rev. o • 11/1156
15
15
Appliance Setup
A. Remove the Packaging
Remove the shrink fi lm, corrugated top cap, bottom cap
and column protectors from the appliance. The appliance
should look as shown in Figure 15.1.
Figure 15.1 Appliance Unwrapped
B. Remove the Shipping Materials
Remove the shipping materials from inside and under-
neath the fi rebox.
Latches
(both bottom
and top)
Glass
Assembly
Figure 15.2 Glass Assembly
C. Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
DO NOT:
• Strike, slam or scratch glass
• Operate fi replace with glass removed, cracked,
broken or scratched.
Replace fi xed glass assembly as a complete assembly.
• Pull the four glass assembly latches out of the groove
on the glass frame. Refer to Figure 15.2.
• Remove the glass assembly from the appliance.
D. Remove Glass Media Package
The glass media package is shipped inside the fi rebox.
Refer to Figure 15.1.
E. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
F. Accessories
Install approved accessories per instructions included
with the accessories. Refer to Section 17.
WARNING! Rick of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazad and will void the warranty.