Filter
Top Products
52
Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12
FINISHING
MATERIAL
FINISHING
MATERIAL
IF FINISHING MATERIAL IS THICKER THAN
1-1/2 IN. DOORS WILL ONLY OPEN AS FAR
AS PICTURED
1-1/2 IN.
MEASURE FROM
FIREPLACE OPENING
Figure 13.16 Minimum Side Clearance for Operable Doors
A
B
COMBUSTIBLE MATERIAL
C (ARCH)
DIMENSION
INOPERABLE
DOOR
OPERABLE
DOOR
A 3/4 IN. 1-1/2 IN.
B 1-1/4 IN. 1-1/4 IN.
C 1-1/4 IN. 1-1/4 IN.
Figure 13.15 Inside Fit Doors
Table 13.1. Approved Doors (Decorative Fronts)
E. Doors
A door (decorative front) is required for this appliance.
Only doors certifi ed for use with this appliance model
may be used. Contact your dealer for a list of doors that
may be used. Once you have determined what kind of
door and fi nishing material is going to be used on the fi re-
place, you may use the table below which shows the door
models and the fi nishing material thickness allowed. For
an inside fi t there is an available template to ensure that
proper door clearances are maintained with fi nishing ma-
terial with thickness greater than 1 in.
Two styles of decorative doors are approved for use with
this appliance: Operable cabinet-style doors and non-op-
erable doors.
The doors approved for use with this appliance have been
designed to be installed by two methods: Overlap Fit or
Inside Fit. Before beginning the installation, it is important
to determine with method will be used.
Overlap Fit Doors: These doors have been designed to
be installed over fi nishing material up to one inch thick.
Inside Fit Doors: These doors may be recessed into
non-combustible fi nishing material up to 6 inches thick.
NOTICE: Proper clearances from the fi replace opening
to any fi nishing material thicker than 1 inch MUST be
maintained.
NOTE: Figure 13.16 shows the minimum clearance from
fi replace opening to adjacent fi nishing materials greater
than one inch thick for operable doors. The 1-1/2 inch
clearance will allow the doors to open to 90 degrees.
Increasing clearance from the fi replace opening to the
adjacent fi nishing materials will allow the doors to open
past 90 degrees.
NOTE: Finishing templates are included with this product.
See Section 13.A.
OPERABLE DOORS
RECTANGULAR
CS-36
CS-42
CS-50
INOPERABLE DOORS
RECTANGULAR ARCHED
FS-36 FS-36A
FS-42 FS-42A
FS-50 FS-50A