Filter
Top Products
37
Heatilator •
HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12
9
9
Appliance Preparation
A. Vent Preparation
Figure 9.2 Seal Cap and Gasket Location
SEAL CAP
SEAL CAP
GASKET
GASKET
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: This appliance is top vented ONLY.
1. Remove shrink wrap from appliance. Figure 9.1 shows
the shipping location of the seal cap and heat shields
(Section 9), splatter guard and fi nishing templates
(Section 13), and the lava rock and logs (Section 14).
2. Remove seal cap from top of appliance by removing
one screw, which is included, to prevent construction
material from getting into appliance. Remove seal cap
when pipe installation phase begins. See Figure 9.2.
3. Ensure gasket seal is in place prior to installing vent
pipe sections. Gasket is installed at the factory.
SEAL CAP
SEAL CAP
LOGS
LOGS
SPLATTER GUARD
SPLATTER GUARD
HEAT SHIELDS
HEAT SHIELDS
LAVA ROCK
LAVA ROCK
FINISHING
FINISHING
TEMPLATES
TEMPLATES
(NOT SHOWN)
(NOT SHOWN)
Figure 9.1 Shipping Location of Components