Filter
Top Products
15
MOBILE HOME INSTALLATION
AN OUTSIDE AIR KIT IS REQUIRED
FOR MOBILE HOME INSTALLATION.
You must use an outside air kit (see Outside Air Kit In-
stallation) for installing in a mobile home. Use of alterna-
tive material will void warranty.
1. An outside air inlet must be provided for combus-
tion and be unrestricted while unit is in use.
2. Unit must be secured to the mobile home struc-
ture by bolting pedestal through hearth pad and
into floor.
3. Do not install unit in a sleeping room.
4. The structural integrity of the mobile home floor,
walls, and ceiling/roof must be maintained (i.e.,
do not cut through floor joist, wall stud, ceiling
truss, etc.).
5. Unit must be grounded with #8 copper grounding
wire or equivalent and terminated at each end
with N.E.C. approved grounding device.
6. Refer to clearance to combustibles section (Fig-
ure 5) for listing to combustibles.
7. Seal all wall/floor inlets to prevent air or moisture
penetration. Check periodically to insure the in-
let is free of obstructions (e.g., snow or ice).
8. Burn wood only. Other types of fuels may gener-
ate poisonous gases (e.g., carbon monoxide).
9. If unit burns poorly while exhaust blower is on in
home, increase combustion air.
NOTE: Offsets from the vertical, not exceeding 45°,
are allowed per Section 905(a) of the Uniform Me-
chanical Code (UMC). Offsets greater than 45° are
considered horizontal and are also allowed, providing
the horizontal run does not exceed 75% of the verti-
cal height of the vent. Construction, clearance and
termination must be in compliance with the UMC Table
9C. This installation also complies with NFPA 211.
FIGURE 18
LEG KIT INSTALLATION
WARNING: Do not operate your stove
before fully assembling all compo-
nents. Burning your stove without a
pedestal or leg kit attached will void your
warranty, and could present a safety
hazard.
1. Place protective pad or stove pallet
on floor (see Figure 18).
2. Lay body of stove on its back on pro-
tective pad or pallet.
3. Slip washer onto bolts, then bolt legs
onto adapter plate.
4. Carefully stand stove up and place
in desired location.
5. Open door of stove and check to in-
sure firebricks and koawool blanket
are in their proper location.