Filter
Top Products
25
LIGHTING INSTRUCTIONS
TO TURN OFF GAS APPLIANCE
1. Open the bottom grille.
2. Turn ON/OFF switch to "OFF".
3. Turn the valve control knob clockwise to
the "Pilot" position, then depress knob and
continue turning to "OFF" position.
4. Close the bottom grille.
2.3 LIGHTING INSTRUCTIONS
2.2 SAFETY INFORMATION
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
C. Use only your hand to push in or turn the gas con-
trol knob. Never use tools. If the knob will not push
in or turn by hand, don’t try to repair it. Call a quali-
fied service technician. Forced or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been un-
der water. Immediately call a qualified service tech-
nician to inspect the appliance and to replace any
part of the gas control system which has been un-
der water.
THERMOPILE PILOT BURNER
6. To put the control in the pilot position, turn the
control knob counter-clockwise to the
"Pilot" position.
7. To light the pilot depress the control knob and then
depress the red piezo button until it makes a
clicking sound. It may be necessary to repeat this
step. If the pilot does not light after 10 seconds, go
back to step 3. The control knob should be held
down for a MINUTE after pilot ignition.
• If the control knob does not pop out when released,
STOP-shut off the gas supply to the heater control
valve, and IMMEDIATELY call your service
technician or gas supplier.
• If the pilot will not stay lit after two tries, turn the
control knob to the "OFF" position and call your
service technician or gas supplier.
8. After the pilot has been lit, the burner can be turned on
by turning the knob counter-clockwise to
the "ON" position. Flip the ON/OFF switch to the
"ON" position.
9. Close the bottom grille.
10.When using accessories leave rocker switch in
the "OFF" position.
1. "STOP!" Read the safety information.
2. To access controls, rotate the bottom grille down.
3. Turn the valve control knob to the "OFF" position. To
do this, you must turn the knob clockwise to
the "Pilot" position, and then press in and continue
turning clockwise to the "OFF" position.
GAS CONTROL VALVE
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY
GAS. Then smell for gas, including near the floor. If
you then smell gas, STOP! Follow "B" in the safety
information above. If you don't smell gas, go to the
next step.
5. The pilot should not require accessing for lighting
purposes. The pilot is located inside the combustion
chamber.