Filter
Top Products
Page 9
Yosemite Wood Stove
7004-187F September 1, 2008
R
WHEN LOCATING YOUR STOVE consider safety, convenience,
traffic flow, and the fact that the stove will need a chimney and
chimney connector. It is a good idea to plan your installation
on paper, using exact measurements for clearances and floor
protection, before actually beginning the installation. If you’re
not using an existing chimney, place the stove where there will
be a clear passage for a factory-built listed chimney through
the ceiling and roof.
AVOID FIRE: Maintain the designated clearances to combustibles.
Insulation must not touch the chimney. You must maintain the
designated air space clearance around the chimney. This space
around a chimney is necessary to allow natural heat removal
from the area. Insulation in this space will cause a heat buildup,
which may ignite wood framing. NOTE: Clearances may only
be reduced by means approved by the regulatory authority
having jurisdiction.
WE RECOMMEND that you have a qualified building inspector
and your insurance company representative review your plans
before installation.
LOCATING YOUR STOVE
SIDE FUEL-LOADING-DOOR LOCKING
MECHANISM
The side fuel-loading-door is shipped locked in place. See Figure
9E. You must first decide where you are locating your stove and
determine if you meet the minimum required clearances from
combustibles for loading wood into the firebox from the side door.
If you do not meet the clearances found on page 6, leave the door
locked in place. If you unlock the door without meeting the minimum
required clearances YOU WILL VOID YOUR WARRANTY AND
ASSUME ALL RESPONSIBILITIES. If you meet the minimum
clearances, follow the steps below to unlock the door. If in the
future you decide to relocate your stove, again determine if you
meet the mimimum required clearances to combustibles in the new
location. If you do not, you are required to lock the door shut and
it must remain locked at all times.
Locked Position
Unlocked
Position
Door Lock
Screw
INSTRUCTIONS TO UNLOCK SIDE FUEL DOOR
1. Open front door.
2. Using a Phillips head screwdriver, remove the screw from the
locking bracket. Figure 9D.
3. Rotate locking bracket to horizontal position and secure in
place using the same screw.
Figure 9E
IMPORTANT!
If stove is relocated it must meet minimum required
clearances in new location in order to use the side fuel
loading door or door must be locked in place.
Figure 9D
LEG LEVELING SYSTEM
Figure 9C
Bolt fully extended
Figure 9B
Figure 9A
1. Thread Allen bolts through nuts until flush. Figure 9A. The
Allen bolts and nuts are included in the component pack inside
the stove firebox.
2. Slide assembled nuts and bolts into slots on legs with the nuts
on the bottom. Figure 9B. Use a 5/32" (3.96mm) Allen wrench
to adjust legs up and down to desired level. Figure 9C