Filter
Top Products
Page 25
Yosemite Wood Stove
7004-187F September 1, 2008
R
MAINTENANCE
6
1
1
2
3
3
3
3
5
4
4
4
4
4
4
BRICK REPLACEMENT INSTRUCTIONS
Brick Set Part Number: BRICK-7004
T
he firebox of your stove is lined with high quality firebrick which
has exceptional insulating properties. There is no need for a grate,
simply build a fire on the firebrick.
1. Be certain coals are completely cold. Remove all old brick
and ash from unit and vacuum out firebox.
2. Remove new brick set from box and lay out to diagram
as shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of firebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side of
firebox and push the bottom of the brick until it is flush with
the side of the unit.
Use Part 832-0550 when
ordering individual brick.
Provide brick dimension
or copy this page, mark
the desired brick and
take it to your authorized
dealer.
1. Remove all ash from firebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove ceramic blanket and baffle together.
3. With a 3/16” Allen wrench, remove the front manifold tube
retainer bolts on the air channel under the end of the
front tube. See Figure 25A. NOTE: Soak the bolts with
penetrating oil for at least 15 minutes before trying to remove
it.
4. To remove manifold tube, slide the tube to one side until
one end is out of its hole. Then, while lifting that end of the
fiber board baffle, pull tube up over the air channel and out
of hole at the other end.
5. Slide fiber board baffle forward to front of stove and straight
out through door. See Figure 25B.
6. To install the fiber board baffle, repeat steps 2 through
4 in reverse. Be sure the fiber board baffle and ceramic
blanket are fully pushed back into position and the blanket
is down flat. The front of the blanket should be flush with
the front of the baffle.
NOTE: The baffle is 2700° Fiber Board. Removing hardware
exposed to combustion processes can be frustrating. If your
reason for removing the baffle is simply to clean the chimney,
you have alternatives which will save time and effort. Call a
qualified chimney sweep or an authorized Quadra-Fire dealer
for details.
BAFFLE REMOVAL & INSTALLATION
Ceramic Blanket
Baffle Board
Push baffle board up slightly to
allow room to turn the handle
Baffle Board
Figure 25B
Figure 25A
1
5-3/8"
4-1/2"
70.0
o
6
7-1/2"
2-1/4"
1-1/2"
4-1/2"
1-1/2"
Nbr Brick Size Qty
1
5-3/8" x 4-1/2" x 1-1/4"
(see drawing)
2
2
9" x 4-1/2" x 1-1/4”
1
3
5-3/8” x 4-1/2" x 1-1/4"
4
4
7-1/2" x 4-1/2" x 1-1/4"
6
5
7-1/2" x 2-1/2" x 1-1/4"
1
6
7-1/2" x 4-1/2" x 1-1/4" with
hole 1 (see drawing)
1