Filter
Top Products
Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/0756
STEP 4.
LOG #3 (SRV2066-702) Place log #3 on right side of
grate. The notch on the log should fi t over the bar on the
far right side of the grate. Push the right side of log #3
against the grate tab and pull the left side forward until
it comes into contact with the burner detail as shown in
Figure 1.
STEP 5.
LOG #4 (SRV2066-705) Place log #4 so that the notch
is touching the fi rst grate tine and is laying in the fl at spot
of log #2. The right end of log #4 should touch the back
refractory panel. See Figure 2.
STEP 6.
LOG #5 (SRV2065-701) Place log #5 on log #2. Log #5
will mate with the grooves located on the top side of Log
#4. See Figure 3.
1
1
2
2
3
3
4
4
2
2
1
1
2
2
3
3
5
5
3
3
4
4
1
1
NOTCH
Figure 2.
Figure 3.
NOTCH
LOG TOUCHES REFRACTORY PANEL
Figure 1.
LOG/BURNER DETAIL CONTACT AREA
MATE WITH GROOVES HERE