Filter
Top Products
Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/07 51
Model: SL-350TRS-D
F. Positioning the Logs
CAUTION: Logs are fragile. Log #1 (SRV2113-701): Locate the slot on the bottom right side of log 1. Mate the slot with the
right rear log tab. Pull the front left nose of log #1 forward until it touches the left rear log tab.
Log Set Assembly: LOGS-350TRS-D
Left rear log tab
Left rear log tab
Lava rock retainer
Lava rock retainer
Grate tine (4)
Grate tine (4)
Log #2 (SRV2113-702):Locate the notch at the left end of
log # 2. Mate the notch with the tine as shown above. The
top end of log #4 should rest on the groove that is located
on the top of log #1. Swing the center branch toward the
burner (see above).
1
1
Mate slot with tab
Mate slot with tab
Left rear log tab
Left rear log tab
Groove used to locate log # 2
Groove used to locate log # 2
2
2
Mate log with tine
Mate log with tine
Mate log with groove on log # 1
Mate log with groove on log # 1
Tip should touch log # 2
Tip should touch log # 2
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
Figure 5
Right rear log tab
Right rear log tab
Shoulder screw
Shoulder screw
Swing branch towards burner
Swing branch towards burner
Groove used to locate log # 3
Groove used to locate log # 3
Log # 1 should rest on log # 1
Log # 1 should rest on log # 1
Mate “Y” with groove
Mate “Y” with groove
Log #3 (SRV2113-704): Locate the “Y” end of log # 3. Mate
the “Y” end with the groove on log # 2 (see above illistration).
Log # 3 should rest on log # 2, as shown above. The tip of
log #3 should touch log # 2.
3
3
3/8 in.
Burner
Lava Rock
retainer
No lava rock
may be placed
past this edge.
Note: Figure 1 illustrates the recommended gap between the
burner and the lava rock retainer.
Figure 1
21113-935B