Filter
Top Products
Page 1
5100-I ACT WOOD INSERT
R
438-0380D
September 1, 2008
F. Masonry Fireplace
UL 1777 Insulated Stainless Steel
Liner or Other Approved Lining System
Follow Manufacturer’s Instructions
on Insulation and Support
For Zero or Other Non-Code Clearances,
Follow Approved Liner Manufacturer’s Specific
Insulation Requirements: Different Clearances
May Require Different Specifications
Masonry Chimney Must
Have Structural Integrity
UL 1777 Insulated Stainless Steel
Liner or Other Approved Lining System
Minimum 8 in. (203mm) Masonry
Thickness in Front of Smoke Chamber
Damper Plate Removed or
Fastened in Open Position
Seal with Non-Combustible Material
Minimum Clearance in Accordance
with Insert Listing
Floor Protection in
Accordance with Insert
Listing
Follow Manufacturer’s
Instructions for Maximum
Liner Extension Above
Chimney
Maximum 30 Degrees
Offset in Chimney
Combustible Floor
The Quadra-Fire 5100-I Insert conforms with the UL 18
and ULC S68 (Canada) in all respects, and is approved to
UL & ULC safety standards for installation and use within a
replace with a masonry chimney in accordance with NFPA
211.
In the USA all masonry replace installations require a stain-
less steel liner connector pipe extending to the rst ue liner
of the existing code approved masonry chimney. In Canada,
a full reline is required.
NOTE: In Canada, the chimney liner must conform to
the Class requirements of CAN/ULC-S65, Standard
for Lining Systems for Existing Masonry or Factory-Built
Chimneys and Vents, or CAN/ULC-S60, Standard for
Lining Systems for New Masonry Chimneys.
NOTE: Installation into replaces without a permit will
void the listing.
Figure 17.1