Filter
Top Products
23
P68 Pellet Stove
Exposed blower wheel
and flue opening, NOTE:
ESP probe is visible.
Blower cover
removed.
ESP
probe
ESP
Probe
8. Clean the combustion blower wheel with a brush and
a vacuum cleaner. Note: Do not use a household
vacuum to clean the stove. We recommend that you
use a shop vacuum that is equipped with a fine dust
filter called a HEPA filter or a vacuum specially made
for fly ash and soot. USING A VACUUM WHICH IS
NOT EQUIPPED WITH A FINE DUST FILTER WILL
BLOW FLY ASH AND SOOT OUT INTO THE ROOM.
NOTE: THE STOVE MUST BE COMPLETELY OUT
BEFORE YOU VACUUM THE STOVE. LIVE PEL-
LETS, IF SUCKED INTO THE VACUUM WILL LIGHT
THE VACUUM ON FIRE AND MAY ULTIMATELY
CAUSE A HOUSE FIRE.
9. Use a brush to clean the flue, being careful not to
damage the ESP probe, see Fig. 30. The flue goes
straight through into the vent pipe (Fig.27) therefore,
the vent pipe can also be cleaned to some extent
through the flue outlet.
10. Reinstall blower cover and relatch.
11.Slide ash pan into stove and latch the door.
Fig. 28
Fig. 29
Fig. 30
Fig. 31
Fig. 33
Be careful not to
damage ESP probe
when cleaning with
brush.
Soot and Fly Ash
The products of combustion will con-
tain small particles of fly ash which must
be removed from the inner walls of the
stove and from the venting system peri-
odically. Removing fly ash and soot
improves efficiency, insures that the
flue venting passageway is clear and
unobstructed. The stove should be
cleaned after each ton of pellets (50
bags) and the venting system
inspected and cleaned after
each heating season.
Maintenance
Clean-out plate
Latch "open "with blower
cover partly removed. Burn
pot clean-out is open.
Latch "closed "with blower
cover in place. Burn pot
clean-out is closed.
Fig. 32
Brush not
supplied. Can be
found in
hardware stores.
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.