Filter
Top Products
21
P68 Pellet Stove
The room sensor is a small temperature sen-
sor on the end of a 60" gray wire. This sensor is
installed much like a standard wall thermostat. Be-
cause it is so small, it can be hidden along the trim
of a doorway or even up the leg of a coffee table.
There is a remote room sensor port on the rear of
the unit for easy external connection. Use standard
18-2 thermostat wire to extend the distance to the
desired location (100' maximum). The room sen-
sor should be installed in the location where you want
to control the temperature.
In most installations locating the room sensor
behind the stove near the distribution fan works well
because the sensor monitors the room air being
drawn into the distribution fan.
NOTE: Distances of more than 25 feet from
the unit or in another room are not recommended.
The room sensor is essential for the P68's excel-
lent efficiency.
NOTE: It is recommended that the room
sensor be installed, even if only installed on the
rear of the unit as a return air sensor.
Fig. 24
Room Sensor Installation
Fig. 25
Room Sensor and Rear Shield Installation
Rear Shields
5/16" Hex Head
Screws (3 on
each side)
5/16" Hex Head
Screws (3 on
each side)
The rear insulated shields are split in the middle for
easy removal. Each shield has (3) 5/16" hex head
screws. Two (2) that only need to be loosened, and
one (1) that needs to be completely removed, to allow
the shield to slide away from the unit. NOTE: It is
not recommended that the unit be operated with
the shields removed, due to the hot and moving
parts which they protect.
Room
Sensor
Port
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.