Filter
Top Products
Open the cover on the thermostat and insert a small
coin or flat-bladed screwdriver in the slot on the top of
the thermostat and twist 1/4 turn. Grasp the base from
the side and remove from the thermostat.
REMOVE BASE FROM
THERMOSTAT
MOUNTING AND WIRING
CAUTION: Disconnect the electrical power
supply before wiring connections are made to prevent
damage to the thermostat.
1
11
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
–
Save these
instructions for local inspector’s use.
•
IMPORTANT
–
Observe all
governing codes and ordinances.
• Note to Installer
–
Be sure to leave these
instructions with the Consumer.
• Note to Consumer
–
Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – 1 hour
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• On an interior wall, since the temperature of an
exterior wall varies with outdoor conditions,
approximately 5 ft (1.5 m) above the floor.
THERMOSTAT LOCATION
If you have questions, call 800-GECARES
or visit our Website at:
www.GEAppliances.com
Installation
Thermostats
Instructions
RAK147P1 RAK163P1
• No less than 18 inches from the junction of an outside
wall and away from direct sunlight, radiant heat, air
discharge grilles, stairwells, outside doors or behind
doors.
• Away from steam pipes, water pipes or warm-air stacks
in adjacent rooms.
5 ft (1.5 m)
18 in.
Pencil
TOOLS REQUIRED
Drill
Screwdriver
Anchors and screws
Hammer
Caulking material
or putty