Filter
Top Products
8
Accessories
PXAA
New Construction Accessories
PDXWS
PDXWSEXT
WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-step
oven for exceptional durability. The wall sleeve is insulated for sound
DEEP WALL SLEEVE EXTENSION For use when the wall is thicker
than 13 1/4”deep. The wall sleeve may be special ordered through your
-
ments..
PXGA
GRILLE Standard, stamped aluminium, anodized to resist chalking and
oxidation.
PXAA
PXBG
PXSC
ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5 alumi-
num alloy:
PXAA – Clear, extruded aluminum
PXBG – Beige acrylic enamel
PXSC – Also available in custom colors.
PXDR10
CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for
-
nal draining. Recommended on all units to remove excess condensate.
Packaged in quantities of ten.
PXSB
DECORATIVE SUBBASE Provides unit support for walls less than
-
ing brackets for electrical accessories. Accepts circuit breaker, power
disconnect switch, or conduit kit.
RT6
DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single
stage heat for PDE models or single stage cool, dual stage heat for
PDH model thermostat features high/low fan speed switch. Thermostat
is hard wired and can be battery powered or unit powered. Features
Friedrich PTACs and Vert-I-Paks.
PDXRTA
REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten
escutcheons that can be placed over the factory control buttons when
a remote wall mounted thermostat is used. The escutcheon directs the
guest to the wall thermostat for operation and retains the LED window to
display error codes and diagnostic information.
PXSE
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel,
2.4" sleeve extension attached to the room side of the sleeve to allow for
the installation of a PD-Series Friedrich PTAC in a T-Series sleeve.
PDXDAA
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP unit and
provides a transition to direct up to 35% of the total CFM to a second-
ary room, either left or right of the unit. Kit includes duct plenum with
PDXDEA
LATERAL DUCT EXTENSION A three-foot insulated plenum that at-
taches to the left or right side of the duct adapter. The extension can be
cut to length by the installer. Maximum allowable straight extension is 15
feet.
PXGA
PDXWSEXT
PDXWS