Filter
Top Products
Page 27
REPLACEMENT PARTS AND REMOVAL INSTRUCTIONS
(Continued)
Removing and Replacing the Firebricks (Continued)
REMOVING THE BOTTOM FIREBRICKS (Continued)
4. Remove the bottom firebricks in the order listed below. Note the position of each firebrick
as they are being removed from the firebox. Certain firebricks have unique dimensions
which require that their relative position is correct when they are replaced.
BOTTOM FIREBRICK (TOP VIEW)
213
4
5
6
9
7
810
5. When replacing any of the bottom firebricks, use firebrick available from your dealer.
Every bottom firebrick is 1 1/4" thick. The other dimensions vary depending upon the
firebrick being replaced. Use the chart below in conjunction with the illustration above to
determine the dimensions of the firebrick to be replaced.
Dimensions of Firebrick
4 1/2"
9"
2 1/2"
4 7/8"
4 1/2"
7 1/8"
4 7/8"
4 1/2"
Brick # 1,2,3,5,6,9 4,7 8,10
Removing and Replacing the Catalytic Combustor
Before replacing the catalytic combustor, make sure it is inoperable by conducting the steps
for testing the catalytic combustor in the section "CARE & MAINTENANCE". The catalytic
combustor is fragile, and should not be removed unless being replaced. Before attempting to
remove the catalytic combustor, allow the fireplace to sit for approximately 24 hours without a
fire.
1. Pull the combustor by-pass control all the way out.