Filter
Top Products
Page 22
CARE AND MAINTENANCE (Continued)
CHIMNEY SYSTEM
CLEANING
We recommend you have your
chimney system and appliance
checked and cleaned by a
competent chimney sweep at least
once a year.
The chimney should be fully sealed
and securely attached.
The chimney termination should be
free of all blockage (ash, leaves,
etc.)
Check to make sure the chimney is
fully sealed and is secure.
Check the chimney
termination for any blockage
(ash, leaves, etc.)
Blower Cleaning
Every year the blower should be cleaned of any dirt or dust that may have accumulated. The
blower housing on your Fireplace Xtrordinair is a separate unit located away from the
fireplace. Locate the intake grill that fits over the blower housing and remove the four screws
that hold the grill in place with a 1/4" nutdriver. Remove both the filter and filter screen.
Vacuum out any dirt or dust that may have accumulated inside the blower housing. Shake
the filter and filter holder to remove any dirt or dust that may have accumulated. Replace the
filter screen, filter (blue side facing the intake grill), and intake grill and re-attach with the four
screws removed. See the illustration below.
Remove the four
screws that go into
these holes with a 1/4"
nutdriver. Then
re-install the grill after
placing the filter screen
d filt i l
Place the filter into
the filter screen
with the blue side
f
ac
in
g
out
w
a
r
ds
.
After removing the intake
grill, insert the filter screen
into the blower housing.
Intake GrillBlower Housing
Filter Screen Filter