Filter
Top Products
$*
1. Set up closed stop points for your gates
if you are choosing to use them. For a snug
closing the master gate should close against
the slave gate using an overlapping bracket
as in the picture to the right. The closed
stop on the ground is for an overall taught
closing point
Examples of stops
Examples of industrial
door stops
2. Position the column bracket to the dimensions from the
previous page. In most installations the gate is already hung
so the distance between A and B is going to dictate the
opening degree and distance to set the bracket on the back
of the column. Before securing the bracket, check for level-
ness.
3. Straighten the arm to it’s full extended position as seen below. This will be the position the
arm will be mounted in the closed position of the gate. See the following page before mounting
the ate bracket.
!