Filter
Top Products
ATTENTION: Study the control board and read this section
thoroughly before attempting to operate your gate opener.
&%
Warnings:
• Before attempting any job on the control board (connections, maintenance), turn
off electrical power and unplug the support battery.
• Install a surge protector upstream of your opener, the opener is not power surge
proof nor will power surge damage be covered under warrantee.
• Always separate power from control and safety cables (push-buttons, receivers,
photocells, etc.). To avoid any electrical noise, use separate sheaths or a shielded
cable (with earthed shield).
%&
%&
LED Programming LEDs
P Power ON and diagnostics LED
P1 “Function” programming push-button
P2 “Value” programming push-button
F1 Battery and motor fuse - F15A
J1 Accessories Terminal board
J2 Transformer Terminal board
J3 Motor connection terminal
J4 Battery connector
J5 Minidec connector/RP receiver
P Power ON and diagnostic LED
F1 Battery and motor fuse - F15A
J2 Bus connection terminal board
J3 Motor connection terminal board
J4 Battery connector