Filter
Top Products
!
3. Charge the slave board by wiring it to the master board terminal strip. [terminal 6
of the master must connect with the right side of J2 on the slave and terminal 15
of the master must connect with the left side of the slave] (fig 3)
NEVER CONNECT POWER FROM ANY SOURCE DIRECTLY TO
THE SLAVE BOARD. The slave board may ONLY be connected to the
Master control board.
Let the unit charge for 12 hours, after remove both the transformer power and the
battery. You can now proceed with the installation process.
Fig 3
From Master
ONLY
Slave Charging