Filter
Top Products
INSTALLATION OF LOGSET and EMBERS INSTALLATION OF LOGSET and EMBERS
INSTALLING THE GLOWING EMBERS INSTALLING THE GLOWING EMBERS
A bag of Rock Wool embers is provided for use on the burner. A bag of Rock Wool embers is provided for use on the burner.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the amount of ember material
there may be more than required.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the amount of ember material
there may be more than required.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest
ENVIROGAS dealer for replacement embers.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest
ENVIROGAS dealer for replacement embers.
Remove the ember material from the
plastic bag.
Remove the ember material from the
plastic bag.
Cover the shaded areas in the
diagram shown beside.
Cover the shaded areas in the
diagram shown beside.
Totally fill these areas with glowing
ember material.
Totally fill these areas with glowing
ember material.
DO NOT PACK DOWN. LEAVE
EMBER MATERIAL LOOSE.
DO NOT PACK DOWN. LEAVE
EMBER MATERIAL LOOSE.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOGSET INSTALLING THE LOGSET
Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log in its
proper position to insure safe, optimum operating conditions.
Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log in its
proper position to insure safe, optimum operating conditions.
• Open the front door. • Open the front door.
• Place each piece of the log set into the
firebox resting on the pins provided.
Ensure that the holes in logs line up.
• Place each piece of the log set into the
firebox resting on the pins provided.
Ensure that the holes in logs line up.
• Close the door and tighten securely. • Close the door and tighten securely.
Upon the first light up, watch for ignition to all
burner ports. If a long delay is noted:
Upon the first light up, watch for ignition to all
burner ports. If a long delay is noted:
• First, wait for the appliance to cool down • First, wait for the appliance to cool down
• Open the front door of the appliance. • Open the front door of the appliance.
• Check to carefully re-position the embers making sure that burner ports are not plugged solid or blocked. • Check to carefully re-position the embers making sure that burner ports are not plugged solid or blocked.
(See adjusting the venturi section to adjust air for proper flame). (See adjusting the venturi section to adjust air for proper flame).
14
14