Filter
Top Products
9
Figure 8: Blower (Fan) Removal.
1. Turn the unit off, allow it to cool down completely, and
remove the door as shown in the MAINTENANCE AND SERVICE
- OPENING THE DOOR..
2. Remove the log set and brick liner.
3. Remove the burner tray assembly, see MAINTENANCE AND
SERVICE - BURNER REMOVAL.
4. Remove the four (4)
5
/16” bolts that hold the blower
mounting plate to the back rewall. Use a light lubricating
oil on screws before removal.
5. Carefully pull the blower assembly into the rebox (see
Figure 7) disconnect the blower leads from the harness and
remove blower.
6. To re-install, check mounting plate gasket if damaged
replace with new one and reverse steps 1 through 4. Refer
to “SECONDARY INSTALLATION - LOG SET AND EMBERS INSTALLATION”.
Maintenance and Service
3. Vacuum the bottom of the rebox thoroughly. Carefully clean off any dust on the logs and remove any
lint from the main burner and pilot burner.
4. After carefully replacing the log and embers in their correct positions (see Secondary Installation -
Installation of Log Set and Embers), and the door has been resealed, re-light the pilot, following the
instructions on the lighting label attached to the unit.
CLEANING PLATED SURFACES:
It is important to note that ngerprints and other marks can leave a permanent stain on plated nishes.
To avoid this, give the face a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the
replace. Never clean the face when it is not cool. Do not use other cleaners as they may leave a
residue, which can become permanently etched into the surface.
BURNER REMOVAL:
The burner may need to be removed for a few reasons, including cleaning under the burner, converting
the unit to a different gas type, or to replace the burner altogether. Proceed only when the unit has
completely cooled down.
1. Remove the door as shown in the MAINTENANCE AND SERVICE - OPENING THE DOOR.
2. Remove the two (2) T-20 screws that hold
the burner in place; one (1) at each of the
rear burner (see Figure 7).
3. Lift the burner assembly (both the front and
rear burners) straight up then out.
To re-install the burner follow steps 1-3 in
reverse. When placing the burner back in the
unit ensure that the venturi box under the
burner is lined up.
REPLACING THE BLOWER:
Figure 7: Screws holding Burner.