Filter
Top Products
Click Configure Update Rate to set how often the device acquires and reports new
measurements (update rate) and to specify the number of times the transmitter skips data
acquisitions between updates to the gateway (PowerSave Skip Multiplier).
Click Default Burst Configuration to reset the burst configuration to default values.
Click Refresh Effective Acquisition Rate to refresh the value in the Effective Acquisition Rate
field.
Click the Sensor tab to display current sensor configurations. You can also edit the sensor
sensitivity value from this page.
Sensor tabFigure 2-24:
Click Configure Sensor x to configure the parameters for the specific sensor.
Click Restore Sensor Default to reset the sensor parameters to default values.
Configuration
MHM-97408, Rev 15 43