Filter
Top Products
8
U.L. Model No.: CF230
How to Assemble Your Ceiling Fan (Standard) (cont.)
6. Place the ceiling cover over the downrod. Be sure it
is oriented correctly (Figure 13).
7. Reinstall the hanger ball (Figure 14) on the
downrod as follows. Route the motor leads through
the downrod. Position the pin through the two holes
in the downrod and align the ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
A loose setscrew could create fan wobble.
8. The fan comes with blue, black and white leads
that are 80” long. Before installing fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
WARNING
!
CEILING
COVER
DOWNROD
Figure 13
CEILING
COVER
DOWNROD
HANGER BALL
PIN
SETSCREW
Figure 14
4. Make sure the grommet is properly installed in the
coupling cover then slide the coupler cover on
the downrod until it rests on the motor housing
(Figure 12).
5. Place the ceiling cover trim ring and ceiling cover
over the downrod. Be sure both pieces are oriented
correctly (Figure 12).
DOWNROD
GROMMET
COUPLING
COVER
CEILING COVER
TRIM RING
Figure 12
HANGER
BRACKET
HOOK
TAB
GROOVE
HANGER
BALL
#8-32 x 1-1/2"
THREADED STUD (2)
NOTE: CEILING COVER, SUPPLY WIRES AND FAN WIRES
OMITTED FOR CLARITY.
9. Screw the two 1-1/4” threaded studs (supplied) into
the tapped holes in the hanger bracket (Figure
15).
10. Carefully lift the fan assembly and seat the
hanger ball in the hanger bracket (Figure 15). The
tab on the hanger bracket must seat in the groove
in the hanger ball.
Figure 15
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
!