Filter
Top Products
9
Diagnostics and Troubleshooting
Diagnostic Display
The diagnostic segment display on the front of the drive shows drive status, FM-3 status, and
fault codes. When a fault condition occurs, the drive will display the fault code, overriding
the status code. The alphanumeric display on the FM-3 provides additional fault information.
The decimal point is “On” when the drive is enabled, and the stop input is not active. This
indicates that the drive is ready to run and any motion command will cause motion. Motion
commands will not cause motion unless you are Ready (R) and the decimal point is “On”.
Display Indication Status Description FM-3 Keypad Display
Ready
The FM-3 and E Series drive system is
functioning normally and is ready to execute a
motion command.
Drive Type Address
Motor Type
Menu Groups
Disabled Power Stage is disabled.
Drive Type Address
Motor Type
Menu Groups
RMS Foldback Motor torque is limited to 80 percent.
Drive Type Address
Motor Type
Menu Groups
Stall Foldback
(E Series drive only)
Drive output current is limited to 80 percent of
drive stall current.
Drive Type Address
Motor Type
Menu Groups
Ready to Run Drive enabled. No stop input.
Drive Type Address
Motor Type
Menu Groups
Homing Home is executing.
Drive Type Address
Motor Type
Menu Groups
Indexing Index is executing.
Drive Type Address
Motor Type
Menu Groups
FM-3 Programming Module Installation Manual