Filter
Top Products
58 • Appendix C: Non-Standard Toxic Gas Sensors Eagle Instruction Manual
NOTE: Allow up to 4 hours after you replace a non-standard toxic
gas sensor, or if charged batteries have not been installed for
an extended period, for the channel to show a normal
response, then calibrate the sensor.
Parts List
Table 9 lists part numbers for replacement parts and accessories of the
Eagle’s non-standard toxic gas sensors.
Table 9: Parts List: Non-Standard Toxic Gas Sensors
Part Number Description
06-1273RK Tubing, 1/4 in. x 1/8 in. PTFE (order by foot; 3 ft. standard;
consult RKI Instruments, Inc., for lengths longer than 3 ft.)
81-0170RK-02 Calibration cylinder, 58-liter (5 ppm SO
2
-in-nitrogen)
81-0175RK-02 Calibration cylinder, 58-liter 10 ppm NH
3
-in-nitrogen)
81-0185RK-02 Calibration cylinder, 58-liter (0.5 ppm PH
3
-in-nitrogen)
81-0190RK-02 Calibration cylinder, 58-liter (2 ppm Cl
2
-in-nitrogen)
81-0195RK-02 Calibration cylinder, 58-liter (5 ppm HCl-in-nitrogen)
ES-23A-NO Sensor, nitric oxide
ES-23AH-ASH3 Sensor, arsine (0 to 1.00 ppm range)
ES-23AHS-ASH3 Sensor, arsine (0 to 0.20 ppm range)
ES-23AH-NO2 Sensor, nitrogen dioxide
ES-23AH-O3 Sensor, ozone (0 to 5.00 ppm range)
ES-23AH-PH3 Sensor, phosphine
ES-23AH-SIH4 Sensor, silane
ES-23E-SO2 Sensor, sulfur dioxide
ES-23R-NH3 Sensor, ammonia
ES-K233-CL2 Sensor, chlorine
ES-K233-F2 Sensor, fluorine
ES-K233-HCL Sensor, hydrogen chloride
ES-K233-HF Sensor, hydrogen fluoride
ES-K233-O3 Sensor, ozone (0 to 1.00 ppm range)