Filter
Top Products
www.desatech.com
116646-01E28
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
O
F
F
P
I
L
O
T
L
O
I
H
ON
OFF
REMOTE
ON
OFF
O
N
Blower Control Knob
(Optional Accessory)
Variable
Control Knob
Selector Switch in
Remote Position
Gas Control Knob
in ON Position
Figure 52 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
OPERATING FIREPLACE
Continued
ON/OFF SERIES
(Model HRC100 and HRC101)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 53).
TO LOCK press both buttons on hand-held
remote control until light stops ashing. Hand-
held remote control is now locked. If the re is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together on
hand-held remote control until the light stops
ashing. The hand-held remote is now unlocked.
Figure 53 - On/Off Hand-Held Remote
Control Unit (HRC100/HRC101)
Control
Button
Indicator
Light
THERMOSTAT SERIES
(Model HRC200 and HRC201)
The hand-held remote can be operated using
either the manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 54). To select Fahren-
heit/Centigrade mode display, carefully press the
˚C/˚F mode button with the end of a paper clip or
similar blunt object.
Manual Mode
1.
Press the POWER and LOCK buttons togeth-
er to turn on the hand-held remote control.
2. Press the MANU button to turn on the
replace.
3. Press the POWER and LOCK buttons
together to turn off the replace.
Auto (Thermostatic) Mode
1.
Press the POWER and LOCK buttons togeth-
er to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by
pressing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the replace.
Note: Do not leave the hand-held remote in the
AUTO mode close to the replace. The radiant
heat from the replace will turn off the replace.
Ideally, place the hand-held remote in the center
of the room facing towards the replace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Figure 54 - Thermostat Hand-Held
Remote Control Unit (HRC200/HRC201)
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F Mode Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or Off
Increases or
Decreases
Room
Temperature
in AUTO
Mode
Digital Display Shows
Temperature and Settings