Filter
Top Products
www.desatech.com
113110-01H22
INSTALLATION
Continued
Log
Shoulder
Screw
Screen
8. Move temperature adjustment back
and forth to insure bimetal is free from
restrictions.
9. Replace cover onto base. (Upon installa-
tion, thermostat must be allowed to sta-
bilize at room temperature for a minimum
of 30 minutes for proper operation).
10. Set switch on replace to Auto position.
11. Set temperature adjustment to desired
setting. This thermostat has been elec-
tronically calibrated at the factory. No
adjustment or leveling is necessary.
WARNING: Read and fol-
WARNING: Do not connect
this switch to any electrical
1. Connect one terminal of 25 ft. wire to
bottom contact of switch (see Figure 32,
page 21).
2. Connect remaining wire terminal to “TH”
terminal on control valve. Make sure that
wire terminals are in the positions on your
unit as pictured in Figure 32, page 21. If
wires are not “crossed” thermostat will not
work.
3. Route 25 ft. wire to a convenient location
to mount your wall switch (no outside
walls).
Burner Support
with Log
Locator Tabs
Figure 35 - Installing Log and Screen
WARNING: Do not connect
-
IMPORTANT: Wire may be shortened but
must not be lengthened.
4. Connect one bare wire end to each of the
terminals of provided wall switch.
5. Install wall switch and cover in wall.
INSTALLING LOG SET AND SCREEN
1. Remove log packaging material and
discard packaging. Gently place log
on burner support (see Figure 35). Log
should t at against top of burner support
and log locator tabs t into slots under log.
Do not allow log to contact ame. If ame
contacts log, soot will be created.
2. Reattach screen by placing notches in
screen frame over shoulder screws and
pushing down.