Filter
Top Products
www.desatech.com
113195-01B
16
35"
17
1
/4"
26
1
/4"
Figure 20 - Rough Opening for Installing
in Masonry Fireplace
3. Install gas piping to fireplace location. This
installation includes an approved flexible gas
line (if allowed by local codes) after the equip
-
ment shutoff valve. The flexible gas line must
be the last item installed on the gas piping. See
Installing Gas Piping to Fireplace Location,
page 12.
4. Carefully set fireplace insert in front of
masonry fireplace with back of insert inside
wall opening.
5. Attach flexible gas line to gas supply. See
Connecting Fireplace Insert to Gas Supply,
page 13.
6. Plug electrical cord into electrical outlet
installed in step 2.
7. Carefully place fireplace insert into masonry
fireplace.
8. Check all gas connections for leaks. See
Checking Gas Connections, page 14.
9. Install trim after final finishing and/or painting
of wall (see Figure 22).
INSTALLATION
Continued
ASSEMBLING AND ATTACHING TRIM
1. Remove three pieces of surround trim from
packaging.
2. Locate four #6 screws, two adjusting plates
with set screws and two shims in the hardware
packet.
3. Align shim under adjusting plate as shown in
Figure 21.
4. Slide one end of adjusting plate/shim in slot
of top surround trim (see Figure 21).
5. Slide other end of adjusting plate/shim in slot
on mitered edge of side surround trim (see
Figure 21).
6. While firmly holding edges of trim together,
tighten both set screws on the adjusting plate
with slotted screwdriver.
7. Repeat steps 3 through 6 for other side.
8. Line up holes in surround trim with holes on
side panels of fireplace surround assembly. At
-
tach with screws provided (see Figure 22).
9. Move heater and surround assembly to fire
-
place opening. Make sure heater and surround
assembly fit properly.
Slot
Side
Surround
Trim
Top
Surround
Trim
Set
Screws
Adjusting
Plate
Mitered
Edge
Figure 21 - Assembling Surround Trim
Shim
Mitered
Edge
Figure 22 - Attaching Trim to Fireplace
Surround
#6 Screws (4)
Trim
Fireplace
Surround
Slot