Filter
Top Products
www.desatech.com
113195-01B 9
CAUTION: This fireplace in-
sert creates warm air currents.
These currents move heat to wall
surfaces next to fireplace insert.
Installing fireplace insert next to
vinyl or cloth wall coverings or
operating fireplace insert where
impurities (such as, but not lim-
ited to, tobacco smoke, aromatic
candles, cleaning fluids, oil or
kerosene lamps, etc.) in the
air exist, may discolor walls or
cause odors.
WARNING: Before installing
in a solid fuel burning fireplace,
the chimney flue and firebox
must be cleaned of soot, creo-
sote, ashes and loose paint by a
qualified chimney cleaner.
Note: Your Vanguard fireplace insert is designed
to be used in zero clearance installations. Wall or
framing material can be placed directly against any
exterior surface on the rear, sides or top of your
fireplace insert, except where standoff spacers are
integrally attached. If standoff spacers are attached
to your insert, these spacers can be placed directly
against wall or framing materials.
IMPORTANT:
Vent-free heaters add moisture to
the air. Although this is beneficial, installing fire
-
place in rooms without enough ventilation air may
cause mildew to form from too much moisture. See
Air for Combustion and Ventilation,
page 6.
IMPORTANT:
Make sure the fireplace insert is
level. If fireplace insert is not level, log set will
not work properly.
CHECK GAS TYPE
Use the correct gas type (natural or propane/LP) for
your unit. If your gas supply is not correct, do not
install fireplace insert. Call dealer where you bought
fireplace insert for proper type fireplace insert.
WARNING: This appliance
is equipped for (natural or pro
-
pane/LP) gas. Field conversion
is not permitted.
INSTALLATION
Continued
ELECTRICAL HOOKUP
(Blower Accessory)
This fireplace insert includes a blower assembly
with an electrical cord. The electrical cord is five
feet in length. You must locate fireplace insert
within reach of a 120 volt grounded electrical
outlet. If not, install and properly ground GA3555,
three-prong 120 volt electrical outlet, in fireplace
insert. Follow instructions included in kit (see
Accessories, page 34).
INSTALLING SURROUND KIT (GS38
OR GS43)
CAUTION: Close masonry
fireplace damper securely be-
fore installing fireplace insert. If
chimney does not have a damper,
block or cap top of chimney.
Failure to cap an open chimney
could cause drafts that can affect
the heater’s performance and
increase surface temperatures.
CAUTION: A GS38 or GS43
surround kit accessory must be
installed on this fireplace insert
before installing into your ma
-
sonry fireplace or wall opening.
Note: Use the accessory which best covers
the existing masonry fireplace opening or wall
opening.
• Model GS38 Surround Kit (for use with fire
-
places with an opening smaller than 30" H and
38" W)
• Model GS43 Surround Kit (for use with fire
-
places with an opening 30" to 36
3
/
4
" H and 38
to 43" W)
1. Using a 5/16" nut driver, remove two shipping
screws and screen (see Figure 5, page 10).
Discard these screws. Remove 5/16" screen
mounting shoulder screws (do not discard).
2. Remove log packaging from firebox cavity.
3. Align holes in left surround side panel with
screen mounting screw holes. Replace 5/16"
screen mounting shoulder screws removed in
step 1 (see Figure 6, page 10). Do not tighten.
Install Phillips screw in bottom (see Figure 6,
page 10). Repeat for right side.