Filter
Top Products
4
104252
PORTABLE FORCED AIR HEATER
70,000 AND 100,000 BTU/HR
This model is furnished with wheels and
handles. Wheels, handles, and the mounting
hardware are found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support
frame. Install wheels on axle.
IMPORTANT:
When installing wheels,
point extended hub of wheels toward
wheel support frame (see Figure 4).
2. Place cap nuts on axle ends. Gently tap
with hammer to secure.
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater
is over wheels. Line up holes on fuel
tank flange with holes on wheel sup-
port frame.
4. Place front handle and rear handle on
top of fuel tank flange. Insert screws
through handles, fuel tank flange, and
wheel support frame. Attach nut finger
tight after each screw is inserted.
5. After all screws are inserted, tighten
nuts firmly.
Air
Inlet
Front
Handle
Hot Air
Outlet
Fuel Tank
Flange
Rear
Handle
Screw
Figure 4 - Wheel and Handle Assembly, 29,3 kW (100,000 Btu/Hr Model) Only
Wheel
Wheel
Support
Frame
Nut
Cap Nut
Extended Hub
Axle
(For 29,3 kW [100,000 Btu/Hr] Model
Only)
ASSEMBLY
(For 20,5 kW [70,000 Btu/Hr] Model
Only)
GROMMET AND FUEL CAP
Within the plastic bag are the following:
• Fuel Cap (1)
• Cushion Grommet (3)
1. Install fuel cap on fuel tank.
2. Install three cushion grommets in holes
on bottom of fuel tank. Install two
grommets on one foot and one grom-
met on opposite foot (see Figure 3).
Grommet
Grommet
Figure 3 - Installing Grommets, 20,5 kW (70,000 Btu/Hr Model) Only