Desa GA9150A Burner User Manual


  Open as PDF
of 12
 
www.desatech.com
901053-01J8
REMOTE CONTROL OPTION

If you are using the HRC100 remote control
option, you must rst connect the leads of
the receiver to the terminal block on the gas
control (see Figure 16).
1. Connect the leads to the male fast-on
terminals marked TH and TPTH.
2. Install a 9V battery (refer to the instruc-
tions included with the HRC100).
3.
Install a 9V battery into the hand held
transmitter.
4. Insert the receiver into the simulated log
control cover, with the raised cylinder t-
ting into the hole in the cover.
5. The cover may be moved aside when op-
eration of the gas control is necessary.
Figure 16 - Connecting Wire Terminals
Control
Valve
INSTALLATION
Continued

If you choose no remote accessories at
this time, the provided jumper wire must be
installed to the terminal block on the gas con-
trol. Connect the lead to the fast-on terminals
marked TH and TPTH (see Figure 16).
OPERATION


WARNING: If you do not fol-
low these instructions exactly,
    
-

 
-


-




• 







 


-



 





LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information
above.
2. Make sure equipment shutoff valve is fully
open.
3. Set selector switch to the OFF position.
WARNING: burner will come
on automatically within one minute
when the selector switch is in the

 previous next