Filter
Top Products
-8 - For more information, visit www.desatech.com
Install a sediment trap between the incoming gas line and the
gas control box (see figure 15). The sediment trap should
extend down a minimum of 3 inches (76 mm) beyond the
center of the pipe.
When routing gas line through conduit sleeve, make sure to
repack insulation to fill gaps between gas line and conduit
sleeve. Compounds used on threaded joints of gas piping shall
be resistant to the action of propane or natural gas.
Compounds should be applied lightly to ensure excess sealant
does not enter the gas line.
Complete your gas line installation by connecting the
incoming gas line to flexible gas line. Secure tightly with a
wrench but do not over-tighten.
PILOT ADJUSTMENT
The pilot or electrode assembly is factory preset for the proper
flame height. Alterations to these settings may have occurred
during shipping and handling. If this is the case, some minor
readjustments may be necessary and should be done by a
qualified service technician. The proper settings for the
thermopile height should be at a distance of 3/8” (10mm) to
½” (13mm) from the pilot flame as shown in figure 16.
SPECIFICATIONS
CAUTION: All gas piping and connections must be teste
d
for leaks after the installation is completed. After ensuring
that the gas valve is on, apply a commercial leak detectio
n
solution to all connections and joints. Bubbles forming
show a leak. Correct all leaks at once. DO NOT USE AN
OPEN FLAME FOR LEAK TESTING AND DO NOT
OPERATE ANY APPLIA
N
CE IF A LEAK IS
DETECTED. LEAK TESTING SHOULD BE DONE BY
A QUALIFIED SERVICE PERSON.
Figure 15 SEDIMENT TRAP
Figure 16 PILOT ASSEMBLY
CD32M CD36M CD42M
Gas Rate (natural) 16,000/23,000 Btu/hr 18,000/26,000 Btu/hr 25,000/35,000 Btu/hr
Gas Rate (propane) 15,000/21,000 Btu/hr 17,000/24,000 Btu/hr 23,000/33,000 Btu/hr
Ignition Piezo Piezo Piezo
Manifold Pressure 3.5" w.c. 3.5" w.c. 3.5" w.c.
Minimum Inlet Supply Pressure 4.5" w.c. 4.5" w.c. 4.5" w.c.