Filter
Top Products
- 9 - For more information, visit www.desatech.com
GLASS PANEL REMOVAL
Before proceeding, make sure gas control valve is in the
“OFF” position.
1. To remove louvers, pull both spring latches (located
in each end of louver) towards center of appliance
simultaneously until disengaged from locating holes.
Repeat for bottom end spring latches and pull louver
outward (see figure 17).
2. Remove screen rod by removing rod loop from glass
door center bracket. Then slide the screen rod either
to the left or right of the fireplace until one of the rod
ends is free to completely remove the screen from the
fireplace.
3. To open the glass door, undo the latches located on
the top and bottom side of the firebox (see figure 18).
Carefully swing the door to the left. The glass is
securely mounted to the firebox by means of five
screws.
LOG INSTALLATION
Each log is marked with a number in the following diagrams.
These numbers will help in identifying the logs when
installed. It is very important to install these logs exactly as
instructed. Do not modify logs and only use logs supplied
with fireplace.
FOR MODELS CD32M AND CD36M SERIES
• Place log #1 (back log) on top of grate. Make sure
the notches in the bottom of the log fit over the grate.
• Rest log #2 (large front log) on the pins on the front
part of the grate.
• Place log #3 (C-shaped crossover log) onto the rear
and front logs. Make sure it is seated properly on the
smooth surface on the front log and on the pin on the
back log as shown below.
• Place log #4 (small, round log) on the pin on the right
side of front log as shown below.
• Place log #5 (small log) onto the front left part of the
grate making sure the notches fits over the prongs of
the grate.
• Place log #6 onto two pins on the left side of back
and front log.
• Place lava rock along sides and front of firebox
bottom in areas that are visible. It is not necessary to
use all of the lava rock provided.
FOR MODEL CD42M
• Place log #1 (base log) onto pin on left side of grate.
• Rest left side of log #2 (front log) onto top of log #1.
Place right side of log onto second pin located on the
right side of the grate.
Place log #3 (rear log) onto pins on rear of grate.
• Place log #4 (crossover log) onto pins from both logs
#2 and #3.
• Place log #5 (top log) onto right pin of front log (#2)
and the smooth surface of rear log (#3). Make sure it
is seated properly.
Figure 17 LOUVERS
Figure 18 SPRING LATCHES