Filter
Top Products
19
107569
OWNER’S MANUAL
For more information, visit www.desatech.com
Figure 41 - Installing Front Log (#3)
Continued
Figure 42 - Installing Crossover Log (#4)
INSTALLATION
Continued
WARNING: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS (EFP33NR)
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 43). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner “U” bend.
2. Locate pegs on the bottom of back log (#2).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 44).
3. Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 45).
Figure 43 - Installing Middle Log (#1)
Figure 44 - Installing Back Log (#2)
Figure 45 - Installing Front Log (#3)
Middle Log
(#1)
"U"-shaped
Cutout in
Base
Burner
4. Place crossover log (#4) onto the peg
(right) on back log (#2) and into the re-
cess of the middle log (#1) (see Figure 46).
Front Log (#3)
Post
Recess
Post
Crossover
Log (#4)
Rectangular
Knobs
4. Locate the notches in the bottom of the
crossover log (#4). Place the crossover
log on top of the middle log and front
log. Make sure the notches of the cross-
over log lines up with rectangular knobs
on top of the middle and front logs (see
Figure 42).
Front Log (#3)
Grate Fingers
Notches
Back Log (#2)
Peg
Peg
Figure 46 - Installing Crossover Log (#4)
Crossover Log (#4)
Peg
Recess