Filter
Top Products
Fig. 5
Fig. 6
Fig. 7
Fig. 8
2. Assemble the front rail (A) Fig. 5, to front of saw t able
using the two 3/8-16 x 1-1/4 long flat head Phillip s
screws (B), 7/8 flat washers, lock washers and 3/8-16
hex nuts supplied. Screws (B) are inserted through the
two holes in the front rail, as shown and through the two
through holes in the front of the saw t able and fastened
to the t able with the flat washers, lockwashers and hex
nut s. IMPORTANT:Do not completely tighten front
rail mounting hardware at this time.
3. Using the template (D) Figures 6 and 7, check and
adjust front rail at both ends of the saw t able as shown,
to make sure rail (A) is level with t able surface and
tighten rail mounting hardware (B). IMPORTANT:
Template (D) must be on saw table when checking,
not on extension wing.
4. Assemble rear rail (E) Fig. 8, to rear of saw t able
using the two 3/8-24 x 1-1/4 long hex head screws (F),
7/8 flat washers and lockwashers as shown. NOTE:
When mounting fence to Unisaws, the two screws (F) are
threaded into the threaded holes in the saw table, as
shown. When mounting fence to 10 Tilting Arbor Saws
or 10 Contractor s Saws, through holes are provided
instead of threaded holes on the rear edge of the saw
table. In this case the rear rail (E) is fastened to the t able
with the two hex head screws (F) and the flat washers,
lockwashers and hex nuts will be inside the rear ledge of
the saw table.
5 Make certain top edge of rail (E) Fig. 8 is below t able
surface and that top edge of cut-outs (G) are below miter
gage slots before tightening screws (F).
6.If the t able saw is equipped with a left hand sheet
metal extension wing, fasten the front rail (A) Fig. 7, to
the sheet metal extension wing with the 1-1/4 long flat
head Phillip s screw through hole (C) Fig. 7, in the front
rail and through the slot in the sheet metal extension
wing. Fasten the rear rail (E) Fig. 8, to the sheet metal
extension wing with the 1-1/4 long hex head screw
through hole (H) Fig. 8, in the rear rail and through the
slot in the sheet metal extension wing. Fasten both the
front and rear rails in place using the flat washers, lock
washers and hex nuts supplied.
A
B
A
B
D
C
A
B
D
E
F
G
G
F
H