Filter
Top Products
Fig. 24
Fig. 25
Fig. 26
FENCE OPERATION
IMPORTANT: Before operating fence, make sure the fence is adjusted parallel to
the miter gage slot, as explained later on in this manual.
1. To move the fence along the guide rail, simply lif t
up clamp lever (A) as shown in Fig. 24, slide fence to
desired position on rail, and push down on clamp lever
(A) as shown in Fig. 25, to lock fence in position. NOTE:
A magnet (E) Fig. 25, is provided to hold clamp handle
(A) Figs. 24 and 25, in the up position when moving the
fence.
2. The dist ance the fence is positioned away from the
blade is indicated by the witness line (B) Fig. 26, located
on the cursor (C). If it is necessary to adjust the cursor
(C), make a test cut with the fence locked in position.
Measure the width of the finished cut and adjust the
cursor (C) by loosening the two screws (D), adjusting the
cursor (C) until the witness line (B) is aligned with the
same marking on the scale as the finished cut. Then
tighten the two screws (D).
A
A
B
C
D
E