Filter
Top Products
Troubleshooting Your Connections | 19
Troubleshooting Your Connections
Use the suggestions in this section to troubleshoot your MGMT
and LAN connections.
Troubleshooting Your MGMT Connection
If you cannot connect to the Dell SonicWALL NSA 2600 or the
Setup Wizard does not display, consider the following:
• Did you correctly enter the Dell SonicWALL NSA 2600
management IP address beginning with “http://” or “https://”
in your Web browser?
• Did you try restarting your management station while it is
connected to the Dell SonicWALL appliance?
• Are the Local Area Connection settings on your computer set
to a static IP address on the 192.168.1.0/24 subnet?
• Is the Ethernet cable connected to your computer and to the
MGMT port on your appliance?
• Is the connector clip on your network cable properly seated in
the port of the security appliance?
Troubleshooting Your LAN Connection
If you do not see the SonicOS login prompt when you point your
browser to the X0 (LAN) IP address, consider the following:
• Did you correctly enter the IP address for the Dell SonicWALL
NSA 2600 X0 interface into your Web browser, beginning with
“http://” or “https://”?
• Did you try restarting your management station while it is
connected to the Dell SonicWALL appliance?
• Are the Local Area Connection settings on your computer set
to one of the following?:
• Obtain an IP address automatically using DHCP
• A static IP address on the default LAN subnet
(192.168.168.0/24)
• A static IP address on the configured LAN subnet if you
changed it during initial setup
• Do you have the Ethernet cable connected to your computer
and to the X0 (LAN) port on your appliance?
• Is the connector clip on your network cable properly seated in
the port of the security appliance?